Markham Scissor Lift Certification

Markham Scissor Lift Certification - Scissor lift platforms are utilized at work sites to allow tradespeople - like for instance masons, iron workers and welders - to reach their work. Using a scissor lift platform is typically secondary to their trade. Hence, it is important that all operators of these platforms be properly trained and certified. Regulators, industry and lift manufacturers all work together in order to ensure that operators are trained in the safe utilization of work platforms.

Work platforms are also known as manlifts or AWPs. These equipment are stable and easy to operate, even if there is always some risk since they lift individuals to heights. The following are some important safety issues common to AWPs:

To be able to protect individuals working around work platforms from accidental discharge of power because of close working proximities to power lines and wires, there is a minimum safe approach distance (likewise referred to as MSAD). Voltage could arc across the air and cause injury to employees on a work platform if MSAD is not observed.

Caution must be taken when the work platform is lowered to guarantee stability. The boom should be retracted, when you move the load toward the turntable. This will help maintain steadiness when the -platform is lowered.

Regulations do not mandate individuals working on a scissor lift to tie off. However, personnel may be needed to tie off if needed by employer guidelines, job-specific risk assessments or local regulations. The manufacturer-provided anchorage is the only safe anchorage to which harness and lanyard combinations must be connected.

It is essential to observe and not go beyond the maximum slope rating. The grade can be measured by laying a board on the slope or by laying a straight edge. Next, a carpenter's level could be placed on the straight edge and raised until the end is level. By measuring the distance to the ground and dividing the rise by the straight edge's length, then multiplying by 100, the per cent slope could be determined.

In order to determine whether the unit is mechanically safe, a typical walk-around check needs to be performed. Work location assessments are likewise essential to make certain that the work area is safe. This is essential particularly on changing construction sites due to the risk of obstacles, contact with power lines and unimproved surfaces. A function test should be performed. If the unit is used safely and correctly and correct shutdown procedures are followed, the chances of accidents are greatly lessened.

Click to Download the pdf